Requirements to Install Water Heater

Water heaters are a blessing. They keep you warm in the winters and help you cool down when the sun is almost down to drain you. Although they are simple devices but their installation can be a daunting task. All water heaters require proper maintenance in the absence of which you might need to replace your existing heater with a new one. Nevertheless, it is advised that all installations should be handled by professionals for installing it yourself can lead to catastrophes and severe damage to your house. When looking forward to the installation, first pen down the water heater installation requirements just so you do not run out of the necessary items once the work is underway.

Control Gas Valve of water Heater

Control Gas Valve of water Heater

When replacing your water heater, you will need to have a fire extinguisher close by when turning off the gas valve. While doing this, you must ensure that there are no leakages and that the gas is carefully switched off. Then discharge all the water from the heater so that it is easier and lighter to move. Here you will require a pipe wrench to undo the gas line connected to the heater. The pipe wrench is an important tool for it will further be used to disconnect the cold and hot water pipes.

A Teflon tape is another tools which you will need to create strong connections on the flex pipe. In order to tighten the flex pipe, keep an open end wrench close by for it will be used for the tightening of the flex pipe. If your model has copper pipes, you will need a soldering gun for the pipe fittings. However if your pipes are made using rigid plastic, another option is to fix them solvent welding. Before making new connections, it is important that you get rid of the old ones by using a pipe cutter.

Once the old connections are cut off, an emery cloth will be required to burnish the cut ends. If you have decided to solder, you will need to brush it first with paste flux. Since it is hard to gather all the equipments once the installation has started, it is therefore advised that you must collect all the tools so that you the professional individuals can do the installation without any worry. For this reason, below is a quick list of water heater installation requirements which you can take help from:

  • Hacksaw
  • Pipe Reamer
  • Pipe Wrench
  • Gloves
  • Gas Torch
  • Pliers
  • Channel Locks
  • Silver Solder
  • Sand Paper or Emery Cloth
  • Flux and Flux Paste
  • Screwdrivers
  • Pipe Cutter
  • Copper Wire and Fittings
  • Tape Measure
  • Wire Nuts
  • Wire Cutters
  • Teflon Tape

One important thing to consider while replacing a water heater is the length of the pipes. Remember not to cut them too short so that you have enough margin in case you need a long pipe. When cutting or disconnecting pipes, take measurements to be sure so that no issues are faced. Moreover, when you cut off a pipe, ensure that you dress the ends properly. In case the pipes are not well sanded, the soldering will not be proper therefore use a sand paper or an emery cloth to do the job. Always make sure that you cover all connections with a Teflon tape so your installation is strong and proper.

Leave a reply